Vertical mill in the production process, the phenomenon of failure is more, in order to reduce its influence on production efficiency, to timely find the reasons, and timely solve, which is a common production suddenly not discharge phenomenon, in here to introduce the failure reason and solution.

Feed opening point, the product material, in the process of vertical mill production, the bottom of the cyclone separator vertebral chariot, also called loose material, these questions mainly material moisture, perhaps material cause of hot sticky, long-term no fewer than expected will hoarding in the feed opening of cyclone separator, the scene is very simple to ignore, as long as after beating, to make the hoarding material unloading.

2 o 'clock, vertical grinding regulate profiling machine speed and the air volume of fan, air volume, the greater the grinded powder will be more thick, the smaller air volume, grinding the powder will be more fine, and analyze the machine speed and better airflow position according to the material is not the same but not the same, on the basis of fineness of different material and not the same, when regulate a powder fineness, better constant speed is: satisfied with fineness, open to more air volume, such ability ensure the vertical mill produced powder to produce more output, thus invented the user with a larger value;

At 3 o 'clock, you can check whether the air duct of the main engine is blocked, or whether it is caused by air leakage, as well as the loose sealing of the cyclone feeder and the phenomenon of suction. These are also the reasons that will affect the discharging problem.

This article mainly introduces what causes the phenomenon of sudden no material coming out in the process of vertical mill production, and the solutions to these causes. The above analysis of these factors is very detailed.